fret slot depth
Fret Slot Depth Tester
fret slot depth
website fret slot depth The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken fret slot saw My preference is to initially slot shallow and then using a depth stop on my pull saw, set to the fret tang depth, clean up each slot so that
fret slot depth Buy Stewmac Binding Bit here VyJ93M Buy Stewmac Fret Slotting The jig sits over the fretboard blank The fret cutting saw just fits in the slots and the acrylic being 6mm thick should hold the saw square I Slots are normally cut to 023 for most fret wire used today Tang measurement varies a bit dependent upon size but it's usually around 116
Unable to load receipt Availability
