Solidworks Drawing Slot Center Mark by gulfcodes

dimension which is the difference between the upper and lower limits The tolerance of the slot in Figure is 004 and the tolerance of the mating part is

Hole callouts can be applied to cross-sectioned holes and slots, in Click Hole Callout or Insert > Annotations > Hole

slot vivo I am no gd&t expert, but this is how i interpret that callout The parallel tolerance is tighter than symmetry This controls the width of the

slot game safari heat A slot is really just an elongated hole, so first you'd need to know the hole diameter Then you can either call out the dimension from center-to-center on the