Can a Curved Slot Be Placed by GD&T Like This?

The tight key is a connection component fitting into the slot of the shaft and in the hub with torque being transmitted only by the sides of keys The key slots

Can a Curved Slot Be Placed by GD&T Like This? Typically I draw a dimension to the center point of the slot, rather than to both ends of it, but there is no harm in doing it this way

The tight key is a connection component fitting into the slot of the shaft and in the hub with torque being transmitted only by the sides of keys The key slots

slot no deposit required I am trying to create a technical drawing of a simple bracket I have a hole and a slotted hole The important dimension is the distance between

To make the constraining of these slots easier just use a normal General Dimension and choose points to place your angular value When you grab

slot machinescom A basic dimension is shown on a drawing as a dimension inside of a slot) Figure 2: Datum Features A, B, and C Because the datum

Typically I draw a dimension to the center point of the slot, rather than to both ends of it, but there is no harm in doing it this way